The brake pedal method and wiring method of the metal friction plate of the motor:

    1. It is a very common way to install a resistor wheel on the motor and maintain the brake. When the solenoid loses its driving force, the spring of the wet brake friction lining will pull the brake lining, and the mechanical equipment resistor will be locked.

    Connection method: maintain the switching power supply of the brake solenoid coil to connect with the switching power supply of the motor, and apply DC voltage or phase voltage solenoid.

    2. When the motor is turned off and the actual operation is terminated, the emergency braking of the generating capacity and energy-consuming type will be carried out immediately, and the DC current of a relatively limited time and rated value will be transported on the motors of all two stages.

    Wiring method: The DC stabilized power supply comes from the self-distributor, auto-transformer lowering and silicon rectifier. It runs with the motor and terminates the chain franchise, which is performed by the time controller and the AC contactor.

    3. After the motor stops plugging in and stops rotating, the time limit current and its limit resistors and two in turn provide the motor to the rotating switching power supply immediately, and apply the reverse rotation torque to brake. This method is suitable for areas where emergency braking is necessary.

    Wiring method: Link the operation and termination of the motor, according to the timing controller, radio frequency connector and three-phase power connection series with matched high output resistance.