Motor brake pad is a very common equipment, the key is installed in the vehicle. It is very likely that everyone hasn't paid attention to it under normal driving conditions, so it is very easy to be destroyed after a long time, and it needs to be replaced every time. Therefore, Nanjing Tamalink showed several types of upgrade methods, and some common problems in practical operation were introduced in detail for everyone's reference.

    How to upgrade the brake pads of the clutch brake motor

    1. Remove the rear tire, connect the checker, and lift the car;

    2. Turn on the starting motor, release the brake, and enter the test code;

    3. Enter 53 service brake system software;

    4. Enter 04 system software is basically set;

    5. Enter the safety channel number 007, and you can listen to the sound of the motor rotating from the rear tire for about 5 seconds;

    6. Replace the two rear tires with new brake pads after installation.

    The key points to pay attention to when replacing the brake pad of the motor with special tools

    1. In the implementation

    The fault code "Parking brake is invalid" will occur after the "retract brake pump mode" is applied.

    2. Implementation

    The fault code will be automatically eliminated after the "release brake pump mode" is activated.

    3. Identify whether it has succeeded in relaxing or operating the electronic parking mode

    Please observe the LED light on the P button. If it is not on, it means that the relaxation is successful, and it is on that it is successful.

    4. The actual operation must be strictly implemented in accordance with the reminder page and common problems to prevent redundant situations.