When the friction plate is in use, it is very likely that many unforeseen failures will occur. If this failure is not handled immediately, it is likely to cause serious harm to the application for everyone. Then such failures are all What caused it? I summarized it. The key is that the installation does not meet the regulations, the wiring and the connector are unstable, and the brake pedal torque is insufficient. It is very likely that there is another reason because its raw materials are unqualified. Why are its raw materials unqualified?

    1. The installation of brake band and brake pad does not meet the requirements

    The clearance of the friction lining is generally changed and completed when it is completed and put into production. After the modification of the friction lining, the clearance conformity should be approved, and the conformity evaluation shall be carried out through inspection and testing.

    2. Friction plate wiring and connector are unstable

    The connecting edge should be modified together with the connecting edge of the motor stator under the special nut of the connecting wire to ensure that the customer will not impact the old connection stability when connecting the wire.

    3. After the brake pad is plugged in, the friction pad is released

    Perhaps the reasons include the damage of the electromagnetic coil, the switching power supply has not been connected or the working voltage is not enough, the gap is very small during work and it cannot be closed.

    4. Insufficient torque of friction pad brake pedal

    The output power is so low, the working voltage is too large, the friction surface has residue or damage, the spring is lacking or malfunctioning.