Friction linings are more common in daily life. Its application is very common. It can be used in the case of components in clutches and small knife sharpening skills. The raw materials of friction linings will inevitably fail during the whole process of use. , Then, how should the fault of the friction plate be cleared?

    The backplane will fall off. In view of the occurrence of this kind of phenomenon, there are two main reasons: one is that the back plate and the wear-resistant material cause cracks; the other is that the wear-resistant material itself causes cracks. The reason for these two levels caused the backplane to fall. Therefore, to deal with this problem properly, it is not necessary to choose too high temperature to carry out related work, and it is not necessary to choose wrong method to carry out installation, so that the phenomenon of the back plate of the friction lining material from falling can be reasonably prevented.

    The slow phenomenon of braking is also a common problem. If the braking is slow, you must check the spring to see if there is any failure; the gap between the brake friction lining and the brake disc is also harmful, so the gap must be adjusted accordingly. .

    The brake pads that have just been installed will also have soft braking. The key reasons for the occurrence of this phenomenon are: the brake pads are not composite specifications, which must be removed and replaced; the waste on the surface of the brake discs has not been cleaned up immediately. This is also the reason. Therefore, It must be maintained during clean-up work.

    The raw materials of the friction lining can have very good effects on braking and operation. If there is a failure, it should be analyzed immediately for symptomatic treatment.